Tech Forum

HI, I upgraded a Dell studio 1558 notebook to a 2TB drive (Samsung/Seagate ST2000LM003) but can’t install BIBM 1.29a. Actually this is the second drive, since support said a possible reason was a defect in the first sector, but I was able to install to a smaller drive I had lying around. Still, I took it back and got another one. Anyway, the BIOS doesn’t seem to allow writing to some part of the first sector. Letting it create and install its own partition brings me to a Creation of EMBR on HD0 failed.Then when I go into working with partitions and try to change the disk type to EMBR it comes back withThe partition layout could not be changed to match your selection .If I change to BIOS (direct) mode I AM able to change to EMBR, but when I resume installation I get Unable to add entry Finally, when I create an 8MB partition for BIBM in BIOS (direct) mode it works and the MBR changes to reflect it, but I still can’t install. For what it’s worth, the BIOS is up to date (A12). I guess my question at this point is does anyone else have this experience with Dell BIOS, or is there anything else I can try? Any help will be apprecited. I didn't find the right solution from the Internet. References: https://www.terabyteunlimited.com/ucf/viewtopic.php?f=2&t=1825 Cloud Overview Example Thank you.

HI, I have been given a Lifebook C1110, which would not turn on. When the power button was pressed, the fans spin up for about half a second and then everything turns off again. To try to see if i could figure it out, i opened it up and cleaned it. When i tried to start it afterwards, everything worked just fine and i proceeded to install linux on it. When i tried to boot it a week later, it was back to the original state. When the powerbutton is pressed the fans come on for half a second, and the lcd display over the keyboard shows batterystate, discactivity and soforth for the half second while the fans run. Then it turns itself off. If i try many times (pushing the powerbutton repeatedly) it might turn on, and then everything works like a charm untill i power it down. Then everything is back to square one. The problem is the same with and without battery when plugged in, and on battery power. Anybody has any idea what might be wrong, and how i can fix it? It is out of warrenty, and i would very much like to have it working again without handing it for payable service. Any help will be apprecited. I didn't find the right solution from the Internet. References: https://forum.ts.fujitsu.com/forum/viewtopic.php?t=22311 Industrial Valve Video Thank you.

HI, We've just opened a MyLiveChat on our website but we've got a problem to manage the chat. We've downloaded the desktop software, installed it but it doesn't work and open a blank window... Does anybobody encounter the same issue ? Is it another software we can use to use the chat ? Any help will be apprecited. I didn't find the right solution from the Internet. References: http://forums.mylivechat.com/viewtopic.php?f=5&t=1526 animated smart grid video Thank you.